OpenDX Forum
http://www.opendx.org/cgi-bin/forum/YaBB.pl
OpenDX Users >> General Usage and Troubleshooting >> rectangular to cylindrical warped grid
http://www.opendx.org/cgi-bin/forum/YaBB.pl?num=1384165983

Message started by les on 11/11/13 at 03:33:02

Title: rectangular to cylindrical warped grid
Post by les on 11/11/13 at 03:33:02

Hi All,

I am visualising measurements from a cylindrical duct. I used the method detailed in the WarpedGrid.net example. An image is produced but contains the following errors:
1. In my rectangular grid the y coordinate points start at 1.9 m and not 0 m. This creates a region which is not interpolated in the centre of the image. Please advise what modules do I use to ensure this region is interpolated?
2. The warped grid image produces edges on the circumference. I would like it to be completely circular. I assume this can be done with an OpenDX module. Any advice would be appreciated.

Many thanks,
Les

OpenDX Forum » Powered by YaBB 2.1!
YaBB © 2000-2005. All Rights Reserved.